ATTENTION: Fabricmate will be closed for one week from Friday 12/24 to Friday 12/31/2021 in observance of the Christmas and New Year's Holiday. Any orders placed after Tuesday 12/21/2021 will most likely be shipped out on Monday 1/3/2022 at the earliest. We apologize for any inconvenience this may cause. Please plan ahead and order in advance to avoid delays. Fabricmate wishes you and yours a Happy and Safe Holiday.

An Updated Message to our Partners about Coronavirus (COVID-19).
Fabricmate hopes you and your family are staying safe and healthy during this time.
We are open and we are here for you! - read more...

Impaling Pins - Installation Instructions

87 views
0 Likes
0 0
How to use Impaling Pins when installing Raw (uncovered) ReCore®

Share on Social Networks

Share Link

Use permanent link to share in social media

Share with a friend

Please login to send this document by email!

Embed in your website

Select page to start with

1. Single-pin Impaling Clips mount to most surfaces. Available with self-adhesive or perforated variations (to be used with mounting adhesive or screws – sold separately). Compatible with ¼”, ½”, 1”, & 2” semi-rigid insulation. • Anchor must be applied to a clean, dry, non-painted surface • Press anchor on with twisting motion to ensure an even spread • Allow adhesive to dry thoroughly before hanging insulation • Bend the nail if unable to cut it We have a couple of layouts we recommend for the location of Impaling Pins which are outlined below. Examples are showing 4’x8’ ReCore ® . Keep impaling pins about 1’ from the edges/corners. Impaling Pin Layout Option 1 (Example shows 4’x8’ ReCore ® ) Impaling Pin Layout Option 2 (Example shows 4’x8’ ReCore ® ) PERSONAL SAFETY IS ALWAYS THE FIRST STEP IN ANY INSTALLATION PROCEDURE. WORK SAFELY, OBTAIN ASSISTANCE AS NEEDED, AND ALWAYS WEAR SAFETY GLASSES AND PROPER PERSONAL PROTECTIVE EQUIPMENT. THUMB TACKS ARE SHARP. USE CAUTION TO AVOID CUTS AND PUNCTURES AND KEEP AWAY FROM CHILDREN. MAGNETS CAN INTERFERE WITH PACEMAKERS AND OTHER MEDICAL DEVICES. KEEP MAGNETS FAR AWAY FROM MEDICAL DEVICES TO AVOID INTERFERENCE. IMPALING PINS INSTALLATION INSTRUCTIONS 2781 Golf Course Drive, Unit A Ventura, CA 93003 805-642-7470 fabricmate.com P ress the retaining washer onto the substrate so it’s holding snug C ut off the remaining pin as close to the retaining washer as possibl e A dhere base to surface with general purpose adhesive or screw s Carefully impale the substrate a nd add the retaining washer 1’ 1’ 1’ 1’

Views

  • 87 Total Views
  • 65 Website Views
  • 22 Embedded Views

Actions

  • 0 Social Shares
  • 0 Likes
  • 0 Dislikes
  • 0 Comments

Share count

  • 0 Facebook
  • 0 Twitter
  • 0 LinkedIn
  • 0 Google+

Embeds 2

  • 9 www.fabricmate.com
  • 1 fabricmate-solutions.odoo.com